3/8 All-Flo Air Diaphragm Pump Kynar/PVDF & Santoprene 9 gpm

THIS IS THE ONLY PUMP ON THE MARKET THAT WILL ALLOW THE OPERATOR TO CONTROL THE FLOW BY USING ANY NOZZLE SIZE SUITABLE FOR THE JOB. THE SOFTWASHER, CHEMICAL APPLICATOR OR ROOF WASHER CAN CHOOSE TO USE ANY NOZZLE ORIFICE FROM 1.0 TO WIDE OPEN AT 90.

MOST USERS PAIR THIS'CADILLAC OF CHLORINE PUMPS' WITH 200' OF 1/2" ID CHEMICAL HOSE, A 1/2" OR 3/4 PVC BALL VALVE OR CHLORINE GUN, A TT4318S FULL FRAME TITAN HOSE REEL MOUNTED ON ONE OF OUR CUSTOM ALUMINUM BASE PLATES, A TRIBANGER AND THREE NOZZLES TO REACH ABOUT 25-35' ON A ROOF. THIS KYNAR BODIED PUMP DOES NOT NEED TO BE RINSED UNLIKE ALL OTHER PUMPS MARKETED FOR CHEMICALS. Maximum Flow 9 gpm (34.0 lpm).

Maximum Air Pressure 120 psi (8.2 bar). Maximum Solids 1/16 (1.6 mm). Max Suction Lift Dry 15 ft (4.5 m).

Max Suction Lift Wet 26 ft (7.9 m). Max Suction Lift Dry with PTFE 10 ft (3 m). Max Temperature 200 (93) °F (°C). Noise Level (with muffler) 86 dBA. THE MAIN ADVANTAGES OF USING AN ALL-FLO AIR DIAPHRAGM PUMP FOR SOFTWASHING, ROOF WASHING, CHEMICAL APPLICATION AND TRANSFERRING CHEMICAL TO YOUR TRAILER OR TRUCK RIG ARE LISTED AS FOLLOWS.

THE ALL-FLO 3/8 KYNAR AIR DIAPHRAGM PUMP, AFKE038B3, IS DESIGNED TO HANDLE HIGHLY CORROSIVE CHEMICALS SUCH AS SODIUM HYPOCHLORITE (SH) OR CHLORINE, ACIDS SUCH AS ALUMINUM BRIGHTENER OFTEN COMPOSED OF HYDROFLOURIC ACID, SODIUM HYDROXIDE OR CAUSTIC SODA AND A WIDE VARIETY OF AGGRESSIVE CHEMICALS UP TO 9 GALLONS PER MINUTE. WE HAVE FOUND WITH HEAVY DAILY USE, THE DIAPHRAGMS AND AIR VALVE ON THE PUMP USUALLY LAST ALMOST TWO YEARS. THESE ARE THE INEXPENSIVE WEAR COMPONENTS ON THE PUMP. OPERATOR CAN USE PUMP TO CLEAN AND TO TRANSFER CHEMICAL TO TRUCK OR TRAILER RIG INSTEAD OF HAND PUMPING OR PURCHASING ANOTHER PUMP TO DO THE JOB. OPERATOR CAN USE ANY APPLICATOR SUCH AS A 1/2" PVC BALL VALVE, GARDEN HOSE SPRAY NOZZLE, PRESSURE WASHER GUN RESISTANT TO ACID AND CORROSIVE CHEMICALS FITTED WITH A 12' ALUMINUM EXTENSION WAND CONNECTED TO 200' OF 1/2" ID CHEMICAL HOSE. PROTECT YOUR PUMP BY USING AN INTEGRAL FILTER/REGULATOR AND GAUGE, AFB742G, SET BETWEEN 80-90 PSI. DRAIN AND CLEAN THE FILTER DAILY.

USING THE INTEGRAL FILTER/REGULATOR AND GAUGE WILL PREVENT OVER-PRESSURIZATION OF THE PUMP. IT CAN BE INSTALLED ANYWHERE ON THE AIR HOSE LEADING TO THE PUMP. USE ONLY MEDIUM LIQUID THREADLOCK TO PERFORM THE FOLLOWING METAL TO METAL PIPE THREAD INSTALLATIONS.

WE RECOMMEND INSTALLING ONE OF OUR CUSTOM LENGTHS OF GOODYEAR AIR HOSE (HA04-12) ON YOUR COMPRESSOR AND THREADING THE OTHER END INTO ONE OF THE OPEN PORTS OF THE INTEGRAL FILTER/REGULATOR. THE 3/8 ALL-FLO AIR OPERATED DIAPHRAGM PUMP REQUIRES A MINIMUM OF 5.5 GAS HORSEPOWER AIR COMPRESSOR. A HIGHER HP COMPRESSOR IS ALSO SUITABLE FOR POWERING THE PUMP. USING A LESSER HP COMPRESSOR WILL NOT ALLOW FOR MAXIMUM OUTPUT FROM YOUR PUMP. THIS IS CRITICAL FOR OPERATORS REQUIRING ALL 9 GPM AND THOSE REQUIRING MAXIMUM SHOOTING OR SPRAY DISTANCE RANGE.

DRAIN THE TANK(S) AT MINIMUM DAILY. WE RECOMMEND USING 1/2 ID CHEMICAL HOSE AVAILABLE IN CUSTOM LENGTHS OF YELLOW SPIRALITE AG HOSE REB, BLUE OR YELLOW FLEX TECH RT OR OUR BLUE OR RED KURI TEC LIGHTWEIGHT CHEMICAL HOSE.

SOME OPERATORS PREFER TO USE 5/8 ID HOSE. THE SPIRALITE YELLOW AG, FLEX TECH RT AND KURI TEC ARE A RATED FOR USE WITH ALL SOFTWASH CHEMICALS. THE MOST COMMON LENGTH IS A CONTINUOUS 200' PIECE WITH CRIMPED ON HOSE BARBS IN SCH 80 PVC, BRASS OR STAINLESS STEEL USING ONE OF OUR HYDRAULIC CRIMPERS IN HOUSE.

CHEMICAL HOSES ASSEMBLED BY PRESSURE WASHER PRODUCTS DO NOT NEED OR USE HOSE CLAMPS. If All-Flo inspection discloses no defect in material or workmanship, repair or replacement and return will be made at customary charges. All-Flo has made a diligent effort to accurately illustrate and describe its product in this literature. Purchaser shall give written notice of any claim to All-Flo within ten days after discovery of any alleged defect. ALL-FLO SHALL NOT BE LIABLE FOR CONSEQUENTIAL DAMAGES, LOSSES, DELAYS, LABOR COSTS OR ANY OTHER EXPENSE DIRECTLY OR INDIRECTLY ARISING FROM USE OF THE PUMP, ITS LIABILITY BEING EXPRESSLY LIMITED TO THE REPLACEMENT OR REPAIR OF ANY DEFECTIVE PUMP OR AN ALLOWANCE OF CREDIT THEREFORE.

The item "3/8 All-Flo Air Diaphragm Pump Kynar/PVDF & Santoprene 9 gpm" is in sale since Tuesday, October 11, 2016. This item is in the category "Business & Industrial\HVAC\HVAC Parts\Other HVAC Parts". The seller is "thepumpguru" and is located in Clearwater, Florida.

This item can be shipped worldwide.

Brand: ALL-FLO MUM INDUSTRIES
Model: KE 038 B3
Country/Region of Manufacture: United States